Cabinet Planner
« Search Results »

Welcome Guest. Please Login or Register.
Feb 25th, 2018, 12:20pm



Search Results

Total results: 10


 1   General Discussion / Re: Framed Cabinet  on: Feb 23rd, 2018, 4:52pm
Started by tbelk34 | Post by tbelk34
Thanks for the help. sorry for the delay my computor went down. smiley
 
  Reply Quote Notify of replies

 2   Cabinet Planner / Re: Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 3:10pm
Started by timkelco | Post by timkelco
I will just add the dado before I send it to the CNC.

Thank you
 
  Reply Quote Notify of replies

 3   Cabinet Planner / Re: Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 2:56pm
Started by timkelco | Post by Rob
Sorry, no.
 
  Reply Quote Notify of replies

 4   Cabinet Planner / Re: Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 2:48pm
Started by timkelco | Post by timkelco
Can I Dado the bottom/deck to accept the partition? The stretchers too if possible? grin
 
  Reply Quote Notify of replies

 5   Cabinet Planner / Re: Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 2:32pm
Started by timkelco | Post by timkelco
Thank You.


 
  Reply Quote Notify of replies

 6   Cabinet Planner / Re: Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 2:24pm
Started by timkelco | Post by Rob
The program is currently only setup for a rabbit for the backs.
 
  Reply Quote Notify of replies

 7   Cabinet Planner / Re: DXF file parts are stacked  on: Feb 22nd, 2018, 2:18pm
Started by timkelco | Post by Rob
Updates shouldn't change your settings.
 
  Reply Quote Notify of replies

 8   Cabinet Planner / Dado back panel instead of rabbit?  on: Feb 22nd, 2018, 2:15pm
Started by timkelco | Post by timkelco
I like to run a 1/4 dado and slide my back in after the box is assembled. Then put my screw strips on the back of the cabinet. Is this possible or do I need to just live with a 3/4 rabbit?

I am using DXF file imported into my my CNC software.


 
  Reply Quote Notify of replies

 9   Cabinet Planner / Re: DXF file parts are stacked  on: Feb 22nd, 2018, 2:10pm
Started by timkelco | Post by timkelco
I could swear I did that when I first installed the program. I recall something like that in the video. I did do an update, so maybe it changed it back? huh

Thanks Rob
 
  Reply Quote Notify of replies

 10   Cabinet Planner / Re: DXF file parts are stacked  on: Feb 22nd, 2018, 2:02pm
Started by timkelco | Post by Rob
Change the "Output type" in the DXF settings window to "type 2"
 
  Reply Quote Notify of replies


Donate $6.99 for 50,000 Ad-Free Pageviews!

| |

This forum powered for FREE by Conforums ©
Sign up for your own Free Message Board today!
Terms of Service | Privacy Policy | Conforums Support | Parental Controls